MILDTL28803/3D
NOTES:
1. Dimensions are in inches. Millimeter equivalents are given for general information only.
2. Unless otherwise specified, tolerances are ±.02 inch (0.51 mm) for two place decimals and
±.010 inch (0.25 mm) for three place decimals.
3. Design configuration optional within envelope as shown.
4. The values for dimensions A, C, D, E, and M are listed in table I.
FIGURE 1. Type R03 display Continued.
TABLE I. Display assembly and parts dimensions. 1/ 2/
Dimension
Calculation 3/
A
L + .10 (2.54)
M
L + .55 (13.97)
C
L + .90 (22.86)
D
L + .80 (20.32)
E
1/
Dimensions are in inches. Millimeter equivalents are given for general information only.
2/
Unless otherwise specified, tolerances are ±.02 inch (0.51 mm) for two place decimals
and ±.010 inch (0.25 mm) for three place decimals.
3/
Dimension L derived from table II.
TABLE II. Calculation for dimension L.
Type of module 1/
Calculation for L 2/ 3/
Two 7 segment and
Multiply the number of modules by x .60 (15.24)
two decimal points
Three 7 segments
Multiply the number of modules by x .60 (15.24)
16 segment
Multiply the number of modules by .40 (10.16)
9 segment
Multiply the number of modules by .40 (10.16)
Two 7 segment and
Multiply the number of modules by x .40 (15.24)
one decimal point
7 segment
Multiply the number of modules by.20 (5.08)
4 segment
Multiply the number of modules by .20 (5.08)
Colon, decimal
Multiply the number of modules by .20 (5.08)
point, or degree
North South
Multiply the number of N/S or E/W by .40 (10.16)
East West
1/
See table VII for module description.
2/
Dimensions are in inches. Millimeter equivalents are given for general information only.
3/
Unless otherwise specified, tolerances are ±.02 inch (0.51 mm) for two place decimals and
±.010 inch (0.25 mm) for three place decimals.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business