MILDTL28803C
DEPARTMENT OF DEFENSE SPECIFICATIONS
MILDTL28803/1
Display, Optoelectronic, Segmented Readout, Backlighted, Style II (Light Emitting
Diode), RFI Shielded, Moisture Sealed, High Impact Shock, Type R01.
MILDTL28803/2
Display, Optoelectronic, Segmented Readout, Backlighted, Style I (Incandescent
Lamps) RFI Shielded, Moisture Sealed, High Impact Shock, Type R02.
MILDTL28803/3
Display, Optoelectronic, Segmented Readout, Backlighted, Style I (Incandescent),
Dot Pattern And Bar Pattern, RFI Shielded, Moisture Sealed, Type R03.
MILDTL28803/4
Display, Optoelectronic, Segmented Readout, Backlighted, Style I (Incandescent),
Dot Pattern And Bar Pattern, Type R04 (Replacement Parts For Type R03 Display
Assembly)
FEDERAL STANDARD
FEDSTDH28
Screw-Thread Standards For Federal Services.
DEPARTMENT OF DEFENSE STANDARDS
MILSTD108
Definitions of and Basic Requirements for Enclosures for Electric and Electronic
Equipment.
MILSTD202
Electronic and Electrical Component Parts.
MILSTD810
Environmental Engineering Considerations And Laboratory Tests.
MILSTD889
Dissimilar Metals.
MILSTD1285
Marking of Electrical and Electronic Parts.
(Copies of these documents are available online at https://quicksearch.dla.mil or https://assist.dla.mil or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein (except for related associated specifications, specification
sheets, or MS standards), the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with the
applicable specification sheets. In the event of any conflict between requirements of this specification and the
specification sheets, the latter shall govern (see 6.2).
3.1.1 Displays covered by specification sheets and identified by Part or Identifying Number (PIN). Displays which
are completely defined by a Department of Defense specification sheet (see 3.1) shall be ordered in accordance with
3.1.2 Displays covered by specification sheets but not identified by PIN. For displays covered by the specification
sheet but not identified by PIN, the type (see 1.2) shall be specified in the complementary document, such as service
drawings or ordering data sheets (see 6.2.2). Such displays shall be procured from sources listed on the qualified
products list (QPL) for the applicable type.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business